179 research outputs found

    Calculating the 3D magnetic field of ITER for European TBM studies

    Full text link
    The magnetic perturbation due to the ferromagnetic test blanket modules (TBMs) may deteriorate fast ion confinement in ITER. This effect must be quantified by numerical studies in 3D. We have implemented a combined finite element method (FEM) -- Biot-Savart law integrator method (BSLIM) to calculate the ITER 3D magnetic field and vector potential in detail. Unavoidable geometry simplifications changed the mass of the TBMs and ferritic inserts (FIs) up to 26%. This has been compensated for by modifying the nonlinear ferromagnetic material properties accordingly. Despite the simplifications, the computation geometry and the calculated fields are highly detailed. The combination of careful FEM mesh design and using BSLIM enables the use of the fields unsmoothed for particle orbit-following simulations. The magnetic field was found to agree with earlier calculations and revealed finer details. The vector potential is intended to serve as input for plasma shielding calculations.Comment: In proceedings of the 28th Symposium on Fusion Technolog

    Fast-ion redistribution and loss due to edge perturbations in the ASDEX Upgrade, DIII-D and KSTAR tokamaks

    Get PDF
    The impact of edge localized modes (ELMs) and externally applied resonant and non-resonant magnetic perturbations (MPs) on fast-ion confinement/transport have been investigated in the ASDEX Upgrade (AUG), DIII-D and KSTAR tokamaks. Two phases with respect to the ELM cycle can be clearly distinguished in ELM-induced fast-ion losses. Inter-ELM losses are characterized by a coherent modulation of the plasma density around the separatrix while intra-ELM losses appear as well-defined bursts. In high collisionality plasmas with mitigated ELMs, externally applied MPs have little effect on kinetic profiles, including fast-ions, while a strong impact on kinetic profiles is observed in low-collisionality, low q95 plasmas with resonant and non-resonant MPs. In low-collisionality H-mode plasmas, the large fast-ion filaments observed during ELMs are replaced by a loss of fast-ions with a broad-band frequency and an amplitude of up to an order of magnitude higher than the neutral beam injection prompt loss signal without MPs. A clear synergy in the overall fast-ion transport is observed between MPs and neoclassical tearing modes. Measured fast-ion losses are typically on banana orbits that explore the entire pedestal/scrape-off layer. The fast-ion response to externally applied MPs presented here may be of general interest for the community to better understand the MP field penetration and overall plasma response.Marie Curie FP7 Integration PCIG11-GA2012-321455Ministerio de Economía y Competitividad RYC-2011-09152, ENE2012-31087US Department of Energy DE-FC02-04ER54698, SC-G903402, DEFG02- 04ER54761, DE-AC02-09CH11466, DE-FG02- 08ER54984NRF Korea 2009-008201

    Predictive simulations of NBI ion power load to the ICRH antenna in Wendelstein 7-X

    Get PDF
    In Wendelstein 7-X (W7-X), a new ion cyclotron resonance heating (ICRH) antenna will be commissioned during the operational campaign OP2.1. The antenna will have to sustain power loads not only from thermal plasma and radiation but also fast ions. Predictive simulations of fast-ion power loads to the antenna components are therefore important to establish safe operational limits. In this work, the fast-ion power loads from the W7-X neutral beam injection (NBI) system to the ICRH antenna was simulated using the ASCOT suite of codes. Five reference magnetic configurations and five antenna positions were considered to provide an overview of power load behavior under various operating conditions. The NBI power load was found to have an exponential dependence on the antenna insertion depth. Differences between magnetic configurations were significant, with the antenna limiter power load varying between 380 W and 100 kW depending on the configuration. Qualitative differences in power load patterns between configurations were also observed, with the low mirror and low iota configurations exhibiting higher loads to the sensitive antenna straps. The local fast-ion power flux to the antenna limiter was also considered and found to exceed the 2.0 MW m−2 steady-state safety limit only in specific cases. The NBI system might thus pose a safety concern to the ICRH antenna during concurrent NBI-ICRH operation, but additional heat propagation simulations of antenna components are needed to establish more realistic operational time limits

    Effect of plasma response on the fast ion losses due to ELM control coils in ITER

    Get PDF
    Mitigating edge localized modes (ELMs) with resonant magnetic perturbations (RMPs) can increase energetic particle losses and resulting wall loads, which have previously been studied in the vacuum approximation. This paper presents recent results of fusion alpha and NBI ion losses in the ITER baseline scenario modelled with the Monte Carlo orbit following code ASCOT in a realistic magnetic field including the effect of the plasma response. The response was found to reduce alpha particle losses but increase NBI losses, with up to 4.2% of the injected power being lost. Additionally, some of the load in the divertor was found to be shifted away from the target plates toward the divertor dome

    Fast-ion redistribution and loss due to edge perturbations in the ASDEX Upgrade, DIII-D and KSTAR tokamaks

    Get PDF
    The impact of edge localized modes (ELMs) and externally applied resonant and non-resonant magnetic perturbations (MPs) on fast-ion confinement/transport have been investigated in the ASDEX Upgrade (AUG), DIII-D and KSTAR tokamaks. Two phases with respect to the ELM cycle can be clearly distinguished in ELM-induced fast-ion losses. Inter-ELM losses are characterized by a coherent modulation of the plasma density around the separatrix while intra-ELM losses appear as well-defined bursts. In high collisionality plasmas with mitigated ELMs, externally applied MPs have little effect on kinetic profiles, including fast-ions, while a strong impact on kinetic profiles is observed in low-collisionality, low q 95 plasmas with resonant and non-resonant MPs. In low-collisionality H-mode plasmas, the large fast-ion filaments observed during ELMs are replaced by a loss of fast-ions with a broad-band frequency and an amplitude of up to an order of magnitude higher than the neutral beam injection prompt loss signal without MPs. A clear synergy in the overall fast-ion transport is observed between MPs and neoclassical tearing modes. Measured fast-ion losses are typically on banana orbits that explore the entire pedestal/scrape-off layer. The fast-ion response to externally applied MPs presented here may be of general interest for the community to better understand the MP field penetration and overall plasma response.Ministerio de Economía y Empresa ((RYC-2011-09152 y ENE2012-31087)Marie Curie (Grant PCIG11-GA-2012-321455)US Department of Energy (DE-FC02-04ER54698, SC-G903402, DE-FG02-04ER54761, DE-AC02-09CH11466 and DE-FG02- 08ER54984)NRF Korea contract 2009-0082012MEST under the KSTAR projec

    Experimental characterization of the active and passive fast-ion H-alpha emission in W7-X using FIDASIM

    Get PDF
    This paper presents the first results from the analysis of Balmer-alpha spectra at Wendelstein 7-X which contain the broad charge exchange emission from fast-ions. The measured spectra are compared to synthetic spectra predicted by the FIDASIM code, which has been supplied with the 3D magnetic fields from VMEC, 5D fast-ion distribution functions from ASCOT, and a realistic Neutral Beam Injection geometry including beam particle blocking elements. Detailed modeling of the beam emission shows excellent agreement between measured beam emission spectra and predictions. In contrast, modeling of beam halo radiation and Fast-Ion H-Alpha signals (FIDA) is more challenging due to strong passive contributions. While about 50% of the halo radiation can be attributed to passive signals from edge neutrals, the FIDA emission—in particular for an edge-localized line of sights—is dominated by passive emission. This is in part explained by high neutral densities in the plasma edge and in part by edge-born fast-ion populations as demonstrated by detailed modeling of the edge fast-ion distribution
    corecore